Données techniques
CAMLINE FMS
Consisting of 3 pcs. Niigata SPN 63
Horizontal Machining-centre.
Camline Palette magazine for 36 pcs.
Palettes 630 x 630 mm.
As well as 72 European palettes
Year of manufacture 2001
Machine No. 1 Niigata SPN63
Year 2001
pallet 630x630mm
control system Fanuc 16iMA
tool taper BT50
Traverse X 1000mm Y 960mm, 880mm down to pallet movement Z
1000mm
table B-axis 0.001°
probe Renishaw probe system
tool magazine 230 places
spindle speed 12000 rpm
spindle motor 40 Hp - 30Kw
high pressure coolant through spindle
Defects rubber strip in one pallet door
broken
Machine No. 2 Niigata SPN63
Year 2001
pallet 630x630mm
control system Fanuc 16iMA
tool taper BT50
Traverse X 1000mm, Y 960mm, 880mm down
to pallet movement Z 1000mm
table B-axis 1°
probe Renishaw probe system
tool magazine 230 places
spindle speed 12000 rpm
spindle motor 40 Hp - 30Kw
high pressure coolant through spindle
Defects protection over cable trunk bad,
in the magazine net filter chip conveyor broken
Machine No. 3 - Niigata SPN63
Year 1997
pallet 630x630mm 1°
control system Fanuc 16iMA
tool taper BT50
traverse X / Y/ Z table 1000mm 960mm,
880mm down to pallet 1000mm
B-axis 1°
probe Renishaw probe
tool magazine 178 places
spindle 12000 rpm
speed spindle motor 40 Hp - 30
high pressure coolant through spindle
Defects system linear stiffening
magazine shows some signs of wear Gear in changer (carrier) is a cog slightly
defective, nothing that has gotten worse in the last 7 years.
Marchand: SCANTOOL AB
Demande de prix